The bag slips over your feet and legs and then drawstrings shut or you could just use a fleece jacket wrapped around the same area.Another way to trap solar energy is to try outdoor shades. Installing outdoor insulated window shades can keep heat in during cold winter months and keep heat out during summer scorchers. These types of shades come in a variety of styles and colors. They can also be added to decks and patios to provide both insulation and privacy.

　　Solar energy is a largely untapped resource that can save homeowners money while being eco-conscious. There are ways to use solar energy without having to install costly solar panels. Passive solar options are the simplest, do-it yourself ways to optimize solar energy use.

　　In this solar how to, Flame-Retardant Heat Resistant Gloves Manufacturers learn two of the best ways to use passive solar energy: proper insulation and shades. Proper insulation and using layers of sheet rock and concrete creates a high indoor thermal mass. This will lower energy bills by trapping air inside the house.

　　There are different areas of the home where proper insulation could prevent air from escaping. One area is the attic. Two-layers of fiberglass vats work best for this job. When adding the second layer, use un-faced insulation. Also, be sure the second layer is applied across the joists.

　　Walls are an often forgotten aspect of the home when it comes to insulation. Adding layers or plaster will help a home retain energy. Plastering can be a do-it yourself project, although it does require some practice. Before plastering directly onto a wall, practice on a foam board or spare piece of wood.

　　There are several tools necessary to add a plaster layer to a wall. You will need a bucket, stirring rod and plasterers beads to create the plaster. Then you will use a hawk, scarifier, plasterers hawk and float (preferably stainless steel), spirit level and water spray bottle in the application. These materials are available at any home improvement store. Be sure all tools and the surface are clean before starting.

　　When plastering, always work from the bottom left corner upward in a complete vertical section. Load the hawk with plaster and push the plaster from the hawk onto the wall with the float. Do this in firm motions, flattening the plaster upward.

　　Use the scarifier to scratch the plaster. This will create lines that will allow for further applications to adhere to the wall. Once the previous layer has gone stiff, repeat the process.